Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
dsl-group
70
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
dsl-group
To create and configure a digital subscriber line (DSL) group, and enter config-controller-dsl-group
mode, or to automatically configure an ATM or EFM group, use the
dsl-group
command in
configuration controller mode. To disable the DSL group, use the
no
form of this command.
dsl-group
DSL_group_number
{[
pairs
link-number
] | [
auto
]} {
ima
|
m
-
pair
|
efm
-
bond
}
no dsl-group
[
number
]
Syntax Description
DSL_group_nu
mber
DSL group number. Cisco 888EA and EHWIC-4SHDSL-EA support
only one
DSL
group; use 0.
pairs
Defines the DSL wire pairs.
link
-
number
Link number of the pair. Link number options are limited to one of the following
choices, based on the hardware interface and the desired DSL group:
The following information applies to Cisco 888EA and EHWIC-4SHDSL-EA models:
In EFM mode
EFM-bond DSL Group
•
Available links: 0, 1, 2, 3
Any combination of the numbers 0, 1, 2, and 3
For example:
To bond all available links, use:
dsl-group 0 pairs 0-3 efm-bond
To bond only two links (such as 0 and 1), use:
dsl-group 0 pairs 0-1 efm-bond
1-Pair DSL Group
•
Available links: 0, 1, 2, 3
In the case of 1-pair DSL group (2-wire), only one pair needs to be configured.
For example:
To use link 0, use:
dsl-group 0 pairs 0
