Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
shdsl annex
51
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
shdsl annex
To define a symmetric high bit rate digital subscriber line (SHDSL) G.991.2 standard, use the
shdsl
annex
command in the configuration controller DSL group mode.
shdsl annex
{
annex standard
} [
coding
<
tcpam
>]
Syntax Description
Command Default
By default, annex B is supported.
Command Modes
Configuration controller DSL group (config-controller-dsl-group)
Command History
Usage Guidelines
Use the
dsl-group
command to create a DSL group, and then use the
shdsl annex
command to define
the G.991.2 standard for the DSL group.
Note
The annex configuration option is available only for Central Office (CO) termination.
annex
standard
Annex standard for a digital subscriber line (DSL) group. Both standard and nonstandard
Lantiq extensions are supported for annex. The default is annex B.
The following standard annex types are supported for a DSL group:
•
A
•
B
•
F
(Supports both 16 and 32 Trellis Coded Pulse Amplitude Modulation (TC-PAM)
line coding)
•
G
(Supports both 16 and 32 TC-PAM line coding)
•
A-F
(Supports both 16 and 32 TC-PAM line coding)
•
B-G
(Supports both 16 and 32 TC-PAM line coding)
The following nonstandard (extended TC-PAM) annex types are supported for a DSL
group:
•
F
(Supports both 64 and 128 TC-PAM line coding)
•
G
(Supports both 64 and 128 TC-PAM line coding)
•
A-F
(Supports both 64 and 128 TC-PAM line coding)
•
B-G
(Supports both 64 and 128 TC-PAM line coding)
Note
Nonstandard Lantiq extensions are supported only on Ethernet in the first mile
(EFM) mode.
tcpam
TC-PAM line coding. The value can be 16, 32, 64, or 128.
Release
Modification
15.3(2)T
This command was introduced.
