64
Parameters
system-priority
: Specifies the LACP priority of the local system, ranging from 0 to 65535. The smaller the
value, the higher the system LACP priority.
Description
Use the
lacp
system
-
priority
command to set the LACP priority of the local system.
Use the
undo
lacp
system-priority
command to restore the default.
By default, the system LACP priority is 32768.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64
link-aggregation lacp traffic-redirect-notification enable
Syntax
link-aggregation lacp traffic-redirect-notification enable
undo link-aggregation lacp traffic-redirect-notification enable
View
System view
Default level
2: System level
Parameters
None
Description
Use the
link-aggregation lacp traffic-redirect-notification enable
command to enable link-aggregation
traffic redirection.
Use the
undo link-aggregation lacp traffic-redirect-notification enable
command to disable
link-aggregation traffic redirection.
By default, link-aggregation traffic redirection is disabled.
Link-aggregation traffic redirection applies to dynamic link aggregation groups only.
To prevent traffic interruption, you need to enable link-aggregation traffic redirection on devices at both
ends of the aggregate link.
H3C recommends that you do not enable both MSTP and link-aggregation traffic redirection. If they are
both enabled, light packet loss may occur when a card or device reboots.
Examples
# Enable link-aggregation traffic redirection.
<Sysname> system-view
[Sysname] link-aggregation lacp traffic-redirect-notification enable
