NAUT324C-256K
- Technical reference - Rev. B
Page 58
Parameter 9: Right border text mode
Selection/Setting of left text border in mm. Maximum value:= 20 mm
This will reduce the printing width by the set value.
[Parameter example] Right border 10 mm: <ESC>V<9d><10d>
Parameters 13
Power Consumption and Print Dynamics (Quality):
Current peaks are determined during printing through the number of dots that are fed current
simultaneously. Parameter 13 multiplied by 8 indicates how many dots per process may be fed
current simultaneously.
The value range from 1 to 72 allows the simultaneous feeding of current for 8 dots minimum
and 576 maximum respectively.
A large number of dots printed at the same time increases the print speed.
As soon as the number of black pixels to be printed has reached this value within a line section,
the following print line will be filled with zeros, and then current is fed to the line. In the following
cycle, the pixels that have already been printed will be filled with zeros. Afterwards, the next
pixels (maximal n) are being fed current, etc.
Param. Address 15: UART Send Options: (Flag Byte)
Automatic Status Transmission of the status byte:
If this bit is activated, the controller will automatically send the status byte to the host whenever
the status changes.
Auto-Send on
xxxx xxx1 default
(equivalent to command <ESC> a)
Auto-Send off xxxx xxx0 (equivalent to command <ESC> b)
A full data buffer will close the interface. Even the print status inquiry will no longer be
possible in this case. For this purpose, a reset option and the following status inquiry
options have been implemented:
Periodical Transmission of the Status Byte:
If this bit is activated, the controller automatically transmits the current status byte to the host
every 1 second.
Periodical-Send on:
xxxx xx1x
Periodical-Send off:
xxxx xx0x default
