3: Command Line Interface
EDS-MD® Wired IoT Device Gateway Command Reference
14
Note:
To configure the EDS-MD 4/8/16 wired IoT device gateway, you must be in the
enable level and any of its sub-levels.
below shows the enable level
commands.
Figure 3-4 Enable Level Commands
>enable
(enable)#?
auto show interfaces auto show processes
clrscrn configure
connect connect line <line>
device disable
dns email <number>
exit filesystem
iperf <params> kill ssh <session>
kill telnet <session> line <line>
ping <host> ping <host> <count>
ping <host> <count> <timeout> reload
reload factory defaults show
show history show interfaces
show ip sockets show lines
show processes show sessions
ssh ssh <optClientUsername> <host>
ssh <optClientUsername> <host> <port> ssl
tcpdump <parameters> telnet <host>
telnet <host> <port> trace route <host>
trace route <host> <protocol> tunnel <line>
write xml
(enable)#
See the
Chapter 5: Commands and Levels
at the end of this document for a complete list of levels,
commands, and descriptions.
