xxv) GetHiDewpoint
The high (wet) outlet dewpoint alarm level will be returned in milliCelsius.
xxvi) GetHiHiDewpoint
The high (wet) outlet dewpoint fault level will be returned in milliCelsius.
xxvii) GetHiTemperature
The high inlet temperature alarm level will be returned in milliCelsius.
xxviii) GetHiHiTemperature
The high inlet temperature fault level will be returned in milliCelsius.
xxix) GetHygrometerDisplayActivated (3.3 only)
A “1” will be returned if the hygrometer display has been activated at
commissioning. domnick hunter recommend the use of a combined down
stream dewpoint hygrometer on multi-bank PNEUDRI installations.
N.B.
If a “0” is returned the GetDewpoint and AdvDewpoint requests will
return a dewpoint value of –100oC, not the actual dewpoint.
xxx) Get Hygrometer Fitted
A”1” will be returned if the dryer has an hygrometer fitted.
N.B.
as above if a “0) etc.
xxxi) GetLoPressure
The low inlet pressure alarm level will be returned in millibar (gauge).
xxxii) GetLoLoPressure
The low inlet pressure fault level will be returned in millibar (gauge).
xxxiii) GetMachineNumber
Requests the machine number assigned to the dryer connected to the
network node, the returned value will be from 1 to 255.
N.B.
Each dryer connected to the network must have a unique Machine
Number.
xxxiv) GetManufacturerID
Requests the identity of the dryer connected to the network node. This
request will return “DHPNDR” if a PNEUDRI electronic Microprocessor dryer is
connected to the network node.
xxxv) GetMaxOperatingPressure
The maximum operating of the dryer will be returned in millibar (gauge).
xxxvi) GetMinOperatingPressure
The minimum operating of the dryer will be returned in millibar (gau
ge).
23
