MWS_55_e.indb Page 127
Manual MWS 55 / MWS 88 / MWS 10 and Sensors 55
geändert am 04.12.2020 von DO
REINHARDT
System- und Messelectronic GmbH
Fax: 08196/7005 and 1414 email:
wetter@reinhardt-testsystem.de
http://www.reinhardt-wetterstationen.de
ADMIN GET POWER
*ADMIN GET POWER
Returns the assignment of the power switches, set by
ADMIN SET POWER
.
POWER
>1:ON
>2:OFF
>3:OFF
:
:
>31:OFF
>32:OFF
ADMIN SET OUTPUT x ON
ADMIN SET OUTPUT x OFF
*ADMIN SET OUTPUT x ON
*ADMIN SET OUTPUT x OFF
471/5000
This allows the digital output x (1..8) to be switched on (ON) or off (OFF), comparable to the
command DATA Ox ON or DATA Ox OFF
You can temporarily override an automatic circuit set with ADMIN SET OUTPUT x TERM ...
with this command. This should be avoided as far as possible, or be used only in the switching
breaks / inactive phases of the automatic, otherwise the automatic switches within a second again.
ADMIN SET OUTPUT x TERM
<hour>,<...> <Term1><Link><T...2><V...><T...3><V...><Term4>
*ADMIN SET OUTPUT x TERM
<hour>,<...> <Term1><Link><T...2><V...><T...3><V...><Te
rm4>
The command ADMIN STATION OUTPUT x TERM is used to establish an automatic switching
of the output x (1..8) depending on up to 4 sensors.
With <hour> you can select the period in which the automatic switching is active. It can be se-
parated by a comma for several hours, or the typing aids * (for all-day) and + (for 8:00 am - 6:59
pm) can be used. The space between the hours and the terms is important, while there should be
no space between the hours !!
237/5000
For <Term> insert the identifier, the condition operator and the limit value of the sensors.
Conditional operators can be <(less), <= (less than or equal to), = (equal to), >= (greater than or
equal to), > (greater) and <> (unequal).
The limit value is any number, with or without a comma (written as . (full stop))!!
It may also include a range, in this case a lower and, separated by a comma, an upper limit needs
to be entered in brackets.
Here only = (equal) or <> (unequal) are allowed as conditional operators.
As <Link> only & (and) or + (or) are allowed.