Error Messages
16
U2300A Series USB DAQ Programming Guide
159
•
305, "Not able to perform requested operation; user- defined waveform
not set",
•
305, "Not able to perform requested operation; sampling rate cannot
be 0 with user- defined output",
•
307, "Incorrectly configured ref channel",
•
308, "Channel not able to perform requested operation",
•
308, "Channel not able to perform requested operation: currently in
differential mode",
•
309, "Incorrectly formatted channel list",
•
311, "Not able to specify resolution with Auto range",
•
521, "Input buffer overflow",
•
522, "Output buffer overflow",
•
531, "Insufficient memory",
•
532, "Not able to achieve requested resolution",
•
602, "Self- test failed; RAM read/write",
•
626, "I/O processor failed self- test",
•
705, "Cal: aborted",
•
706, "Cal: value out of range",
•
747, "Calibration failed",
•
748, "Cal checksum failed, internal data",
•
748, "Cal: invalid while cal in progress",
•
748, "Firmware and FPGA revision mismatch"
Summary of Contents for U2300A Series
