21
[PRODUCT NAME]
[DOCUMENT TYPE]
Step 5. Before attempting a remote (for example, SSH) connection to the system, check the
mgmt0 interface configuration. Specifically, verify the existence of an IP address. To check
the current mgmt0 configuration, enter the following command:
Step 6. Check the software version embedded in your system, using the command 'show
version'. Compare this version to the latest version that can be retrieved from Grass Valley
support site.
Disable Dynamic Host Configuration Protocol (DHCP)
DHCP is used for automatic retrieval of management IP addresses.
If a user connects through SSH, runs the wizard and turns off DHCP, the connection is
immediately terminated, as the
management interface loses its IP address. In such a case, the serial connection should be used.
switch01 (config) # show interfaces mgmt0
Interface mgmt0 status:
Comment:
Admin up:
yes
Link up:yes
DHCP running:
yes
IP address:
192.168.1.100
Netmask:
255.255.255.0
IPv6 enabled:
yes
Autoconf enabled: no
Autoconf route:
yes
Autoconf privacy: no
DHCPv6 running:
no
IPv6 addresses:
1
IPv6 address:
fe80::202:c9ff:fe63:b55a/64
Speed:
1000Mb/s (auto)
Duplex:
full (auto)
Interface type:
ethernet
Interface source: physical
MTU:
1500
HW address:
00:02:C9:63:B5:5A
RX bytes:
968810197
TX bytes:
1172590194
RX packets:
10982099
TX packets:
10921755
RX mcast packets: 0
TX discards: 0
RX discards:
0
TX errors:
0
RXerrors:
0
TX overruns: 0
RX overruns:
0
TX carrier:
0
RX frame:
0
TX collisions:0
TX queue len:1000
switch01 (config) #
Note:
<localhost># ssh admin@<ip-address
Grass Valley Switch
Management Password:
Grass Valley Switch
Grass Valley configuration wizard
Do you want to use the wizard for initial
configuration? yes
Step 1: Hostname? [my-switch]
Step 2: Use DHCP on mgmt0 interface? [yes] no
<localhost>#
