Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
101
Book Title
DETAILED STEPS
You can remove all dynamic entries by using the
clear mac-address-table dynamic
command in
privileged EXEC mode.
Verifying Dynamic Addresses
Use the
show mac
-
address
-
table dynamic
command to verify configuration:
Router#
show mac-address-table dynamic
Adding Secure Addresses
The secure address table contains secure MAC addresses and their associated ports and VLANs. A
secure address is a manually entered unicast address that is forwarded to only one port per VLAN. If you
enter an address that is already assigned to another port, the switch reassigns the secure address to the
new port.
You can enter a secure port address even when the port does not yet belong to a VLAN. When the port
is later assigned to a VLAN, packets destined for that address are forwarded to the port.
Follow these steps to add a secure address.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
mac-address-table
secure address
hw-addr
interface
interface-id
vlan
vlan-id
4.
end
Command
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
configure
terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
no mac-address-table dynamic
hw-addr
Example:
Router(config)# no mac-address-table
dynamic 0100.5e05.0505
Enters the MAC address to be removed from dynamic MAC address
table.
Step 4
end
Example:
Router(config)#
end
Returns to privileged EXEC mode.
