6-51
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
OL-11503-01
Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
Filtering IP Packets Using Access Lists
To create a standard access list, use the following commands beginning in global configuration mode:
To create an extended access list, use the following commands beginning in global configuration mode:
Command
Purpose
Step 1
Router(config)#
ip access-list
standard
name
Defines a standard IP access list using a name and
enters standard named access list configuration
mode.
Step 2
Router(config-std-nacl)#
remark
remark
Allows you to comment about the following
deny
or
permit s
tatement in a named access list.
1
1.
This example configures the remark before the
deny
or
permit
statement. The remark can be configured after the
deny
or
permit
statement.
Step 3
Router(config-std-nacl)#
deny
{
source
[
source-wildcard
] |
any
}[
log
]
and/or
Router(config-std-nacl)#
permit
{
source
[
source-wildcard
] |
any
}[
log
]
Specifies one or more conditions allowed or denied,
which determines whether the packet is passed or
dropped.
Step 4
Router(config-std-nacl)#
exit
Exits access-list configuration mode.
Command
Purpose
Step 1
Router(config)#
ip access-list
extended
name
Defines an extended IP access list using a name and
enters extended named access list configuration
mode.
Summary of Contents for MWR 1941-DC - 1941 Mobile Wireless Router
Page 49: ...P A R T 1 Implementing the MWR 1941 DC Router in an IP RAN ...
Page 50: ......
Page 107: ...P A R T 2 Implementing the MWR 1941 DC Router in a Cell Site DCN ...
Page 108: ......