Flight
Phase
Program
What is new?
„INC (+)“ and “DEC (-)“:
The two new switches make it possible to change
the values of parameters without the need to take
your hands away from the control sticks.
All servo or mixer adjustments
for which normally only the
rotary selector is used can now
ve
lified.
( i.e. start phase, landing,
s also during
test flights. The application of different adjustments
via switch during flight can help
model set up a lot faster.
The basic programming is done in three steps:
First of all you have to create the flight phases. That
means you just give each phase a name which is
then for example shown in the d
In order to avoid drastic control
phase change the reaction of th
“smoothed“ by applicatio
change over between phases.
With fixed wing programm
stments are
made in Code 51 »
Phase adjus
«. In the Heli
programms you start in Code 49 »
Auxiliary switch
«
if you want to use the delay function, otherwise you
also start in Code 51 »
Phase a
ired “phase switches“ in
The flight phase menus Code 52 and Code 53 ha
been totally reconstructed.
As a result the programming is now much simp
be done by switch activation:
With every activation of the switch the value is either
increased (
INC
) or decreased (
DEC
) by 1%.
Preferably you nominate for each of the “
INC
“ “
DEC
“
command one switching direction of a 2 position
momentary switch (Part-Nr.
4160.44
) or a
3 function gimbal switch (Part-Nr.
4143
).
The advantage of flight phases are obvious:
Often calling certain sections of flight for various flap
settings by fixed wing aircraft or pitch and throttle
ettings in helicopters
s
hover,autorotation etc ).
The flight phase programming makes it possible to
recall such pre sets with the use of auxiliary or logic
switches.
Of great advantage are the flight phase
to find the best
efault display.
movements during
e model can be
n of a time delay for the
ing the adju
t
djust
«.
The next step sets the requ
Code 52 »
Phase assignment
«.
List (and sequence) of neseccary steps for the
programming of the flight phases...
… for fixed wing models:
Page
Code Name
mc-24/1 here
51*
»Phase
adjust«
66
22
52 »Phase
assignment« - 25
… for helicopter with autorotation:
Page
Code Name
mc-24/1 here
49 »Auxiliary
switch« 63
20
51*
»Phase
adjust«
66
23
52 »Phase
assignment« -
new functions
21
25
… for helicopter without autorotation:
Page
Code Name
mc-24/1 here
51*
»Phase
adjust«
66
23
52 »Phase
assignment« - 25
If the phases have been programmed as in the
sequence above, you can start with the
programming of phase adjustments in the phase
dependant menus. ( see table below )
List of flight phase dependant menus by fixed
wing programs:
Page
Code Name
mc-24/1 here
32 »Control
adjust« 47
18
33 »Dual
Rate/Expo« 52
-
51*
»Phase
adjust«
66
22
53 »Phase
trim« 68
26
58
»Non delayed channels«
-
28
71 »Wing
mixer« 74
28
73
»Mix active /phase«
96
-
oder
Summary of Contents for 4831.660
Page 41: ...Programming examples 43 ...
Page 42: ...Personal notes 44 ...
