SCPI Programming
4
Keysight 34934A User’s Guide
229
SCPI Commands Used by the 34934A
Command Summary
The commands listed below are used to control and query the operational state of
the 34934A. Not listed are commands whch apply to all 34980A modules.
In the following subsections are examples which highlight
some
of the more
commonly used commands listed above.
Subsystem
Commands
DIAGnostic
DIAGnostic:RELay:CYCLes? (@<ch_list>)
DIAGnostic:RELay:CYCLes:CLEar (@<ch_list>)
ROUTe
ROUTe:CLOSe (@<ch_list>)
ROUTe:CLOSe? (@<ch_list>)
ROUTe:CLOSe:EXCLusive (@<ch_list>)
ROUTe:CLOSe:PAIR (@<ch_list>)
ROUTe:CLOSe:PAIR? (@<ch_list>)
ROUTe:MODule:BUSY? {slot | ANY}
ROUTe:MODule:WAIT <slot | ALL>
ROUTe:MODule:WAIT? <slot | ALL>
ROUTe:OPEN (@<ch_list>)
ROUTe:OPEN? (@<ch_list>)
ROUTe:OPEN:ALL [{<slot> | ALL}]
ROUTe:OPEN:PAIR (@<ch_list>)
ROUTe:OPEN:PAIR? (@<ch_list>)
ROUTe:OPERation:OVERlap[:ENABle] <mode>
ROUTe:OPERation:OVERlap[:ENABle]?
System - Related
Commands
SYSTEM:MODule:ROW:PROTection <slot>, <mode>
SYSTEM:MODule:ROW:PROTection? <slot>
SYSTEM:MODule:ROW:PROTection DEFault, <mode>
SYSTEM:MODule:ROW:PROTection? DEFault
SYSTEM:MODule:TERMinal:TYPE? <slot>
