KFM2151
4-11
Remote Control
4.5
SCPI Commands
The SCPI commands below are those that are used on the RS232C interface.
4.5.1
IEEE 488.2 Common Commands
*CLS
Clears all event registers including the status byte, event status, and error queue.
Command
*CLS
*ESE
Sets the event status register that is counted by the event summary bit (ESB) of the
status byte.
Command
*ESE <NR1>
*ESE?
Parameter
V
al
u
e:
0 to 255
An SCPI error (-222, "Data out of range") occurs if outside the
range.
(Example)
When *ESE 16 is transmitted, bit 4 of the event status enable register is set.
Each time the execution error bit (bit 4) of the event status register is set, the
event summary bit (ESB) of the status byte is set.
Response
Returns the value of the event status enable register in the <NR1> form in response
to *ESE?.
*ESR
Queries the event status register. This register is cleared when it is read.
Command
*ESR?
Response
Returns the value of the event status register in the <NR1> form in response to
*ESR? and clears the register.
See
See
See
Summary of Contents for KFM2151
