Using the PRO3X Command Line Interface (CLI)
PRO3X User Guide
–
Command Line Interface (CLI)
43 of 182
Setting Data Logging Measurements Per Entry
This command defines the number of measurements accumulated per log entry.
config:#
pdu measurementsPerLogEntry <number>
Variables:
<number> is an integer between 1 and 600. The default is 60 samples per log entry.
Specifying the Device Altitude
This command specifies the altitude of your PRO3X above sea level (in meters). You must specify the altitude of PRO3X above
sea level if a differential air pressure sensor is attached. This is because the device's altitude is associated with the altitude
correction factor.
config:#
pdu deviceAltitude <altitude>
Variables:
<altitude> is an integer between -425 and 3000 meters.
Note that the lower limit "-425" is a negative value because some locations are below the seal level.
Setting the Z Coordinate Format for Environmental Sensors
This command enables or disables the use of rack units for specifying the height (Z coordinate) of environmental sensors.
config:#
pdu externalSensorsZCoordinateFormat <option>
Variables:
<option> is one of the options:
rackUnits
or
freeForm
.
Option
Description
rackUnits
The height of the Z coordinate is measured in
standard rack units.
When this is selected, you can type a numeric
value in the rack unit to describe the Z coordinate
of any environmental sensors or actuators.
Summary of Contents for Server Technology PRO3X
Page 1: ......
