Technical Description &
Configuration Guide
Miscellaneous
Controls in Web
LigoWave
Page 79
Working with Files
The following commands are intended to operate with files stored on the Flash disk on the
management controller.
Command
Description
tfs edit <file>
Edits the specified file. This command is applied for
editing configuration backup files and boot configuration
file (boot.ini). For example,
edit boot.ini,Be
– file „boot.ini‟ will be opened for editing. „Be‟ specifies that
this file will be saved with attributes „B‟ and „e‟. If boot.ini
file is intended to be modified, it should always be opened
specifying „B‟ and „e‟ flags as in the example above, this
will ensure that file is saved with these attributes (flags).
To close the file and save changes press Ctrl+Z, to close
the file without saving changes press Ctrl+Q.
The configuration backup files do not require specific
attributes.
tfs ls
Displays the list of files stored on the Flash disk and
the number of bytes, both free and used by these
files.
‘tfs dir’ can also be used.
tfs cat <filename>
Displays the contents of the text file.
‘tfs type’ can also be used.
tfs del <filename>
Deletes the specified file from Flash disk.
‘tfs rm’ can also be used.
Security Commands
Telnet server supports one user only, web server supports up to 32 users simultaneously. By default
the username and password for Web server, FTP server and Telnet terminal is:
Username (login):
admin
Password:
changeme
The username and password can be changed in Web GUI “System configuration
User
configuration”
„
access set
<username> <password> [plaintext]‟ command.
Take note of upper case and lower case type: it should be taken into account for the password!
The passwords may contain spaces; if using space(s), the password should be entered in quotation
marks.
For Telnet, FTP and Web GUI the password can be changed by simply entering the security command
„
access set
<username> <password> [plaintext]
‟
while logged on and then saving the configuration in
EEPROM by using „
write
‟ command.
To terminate Telnet session press Ctrl+D.
“Guest” account is unable to change its access password.
Specification of the password should always be followed by saving the configuration script
(using “cfg write” command); otherwise, the password request will be ignored after the
restart of LigoPTP 24.
