56
config switch system_timeout
Purpose
Specifies the maximum amount of time a host
can access the management interface. The
default is 5 minutes
Syntax
config switch system_timeout <value 3~30
min>
Description
The command is used to configure the maximum
amount of time a host can access the
management interface.
Parameters <value 3~30 min> -
The timeout time for
management access. The value in minutes may
be between 3 and 30 seconds.
Example usage:
To set the timeout time:
Figure 52. config switch system_timeout command
Basic IP Commands
The basic IP commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
Parameters
config ipif
[ipaddress <network address> {gw
<ipaddress>} | dhcp {vid <vid
1~4094>}]
show ipif
Each command is listed, in detail, in the following sections.