110
802.1x Commands
The 802.1x commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
Parameters
enable 802.1x
disable 802.1x
config radius
<IP> port <port> key <key>
config 802.1x
[auth_configuration [enable_reauth
<enable | disable> | quiet_period
<secs 0-65535> | tx_period <secs
1-65535> | supp_timeout <secs 1-
65535> | server_timeout <secs 1-
65535> | max_req <secs 1-10> |
reauth_period <1>]
Port <port_list> <enable | disable>]
show 802.1x
[auth_configuration | auth_state |
port <port_list>]
Each command is listed in detail below.
enable 802.1x
Purpose
Used to enable 802.1x on the switch
Syntax enable
802.1x
Description
This command allows you to enable 802.1x
Parameters
None.
Example Usage: