User Manual DEV 5072
56
Copyright DEV Systemtechnik GmbH 2016-2017
5.5.4.3.5.10
.application.channelTable.channelEntry.channelModuleStatus
OID:
.1.3.6.1.4.1.21035.34.2.5.1.10.x
Syntax:
INTEGER {ok (1), unplugged (2), commError (3),
wrongVolt (4), notAccepted (5), notApplicable (6)}
Access:
read-only
Description:
The power supply module health status, possible values:
"
1
" ok:
the power supply module status is ok
"
2
" unplugged:
the module is detected as not present
"
3
" communication error: there were detected communication
problems with the module
"
4
" wrong voltage: the installed module type does not match the
DEV 5072 output voltage configuration,
please refer to the note of chapter 3.1.2
"
5
" not accepted: the installed module type is not supported;
"
6
" not applicable: the module status cannot be obtained
5.5.4.3.5.11
.application.channelTable.channelEntry.channelEnable
OID:
.1.3.6.1.4.1.21035.34.2.5.1.11.x
Syntax:
INTEGER {disabled (1), enabled (2)}
Access:
read-write
Description:
The surveillance of the power supply module slot is (can be)
enabled or disabled.
Note:
The factory setting is "
2
" (enabled) for all power supply module slots.
5.5.4.3.6
.application.outputVoltageSet
OID:
.1.3.6.1.4.1.21035.34.2.6
.0
Syntax:
INTEGER32
Access:
read-write
Description:
The output voltage setpoint of the device in [mV]
Note:
Chapter 4.3.1 informs regarding the default setting of this value ("
Voltage
Setpoint
") and the range for adjusting this value is stated in chapter 3.1.2.
5.5.4.3.7
.application.outputCurrentLim
OID:
.1.3.6.1.4.1.21035.34.2.7.
0
Syntax:
INTEGER32
Access:
read-write
Description:
The current alarm level of the device in [mA]
Note:
Chapter 4.3.1 informs regarding the default setting of this value ("
Current
Alarm Level
") and the table at the end of chapter 4.3.1 informs regarding the
adjustment of this value with respect to the present configuration.
