32
emu3/emu3ACO Operation Guide
Version 2.1
Telnet commands
read overcurrent command
This command returns the overcurrent status of a unit
Syntax:
read overcurrent unit_number
Parameters:
Parameter
Value/Options
Description
Result
unit_number
uYY
Command affects
unit number YY
OK
: Current being drawn by unit is below the safe limit
Warning
: Current being drawn is above the warning level
but below the trip level
Error
: Current being drawn is above the trip level. Unit will
trip within 30 seconds if current level is not reduced
Tripped
: Unit has tripped due to current drawn exceeding
the trip level for 30 seconds
Example commands:
read overcurrent u1
Error messages:
Message
Description
Invalid command or exceed max command length
Incorrect command syntax
Not Supported
Unit Number out of range