40 Integra Series
Quick Start Guide
The
ß
key operates in a similar manner except it sequences input channels in a
descending order.
SCPI programming commands (close/open channels)
NOTE
Not all close/open commands are documented here. For details on
all switching module commands, refer to the Model 27xx User’s
Manual (see Section 2).
ROUT:CLOS <clist>
‘ Specify one input channel to close: <clist> = (@SCH), where S
‘ is the slot number and CH is the channel number.
ROUT:CLOS?
‘ Returns list of closed input channels.
ROUT:OPEN:ALL
‘ Open all channels (also disables ratio and channel average).
Remote programming example (close and open channels)
ROUT:CLOS (@106)
‘ Closes input channel 6 of module in slot 1.
ROUT:OPEN:ALL
‘ Opens all channels.
NOTE
When finished with remote programming, press the LOCAL key to
restore front panel control.
Figure 15
Simple scanning
RANGE
AUTO
SHIFT
LOCAL
POWER
RANGE
EXIT
ENTER
DIGITS RATE
REL
FILTER
TRIG
EX TRIG
STORE
RECALL
OPEN
DCV
DCI
MATH
O U T P U T
RATIO
ACV
ACI
Ω
2
Ω
4
FREQ
TEMP
CH AVG
CONT
PERIOD SENSOR
LIMITS
ON/OFF
DELAY
HOLD
SAVE
SETUP
CONFIG
HALT
TYPE
LSYNC
TEST
MONITOR
STEP
SCAN
OCOMP
CH-OFF
CARD
CLOSE
RS-232
GPIB
LIMITS
ON/OFF
DELAY
HOLD
SAVE
SETUP
MATH
O U T P U T
RATIO
CH AVG
TYPE
LSYNC
TEST
RS-232
GPIB
CONT
PERIOD SENSOR
OCOMP
DIGITS RATE
REL
FILTER
Scanning:
Step – Press to start the STEP operation.
Config – Press SHIFT, and then STEP (CONFIG) to
configure a SIMPLE scan.
Scan – Press to start the SCAN operation.
Halt – Press SHIFT and then SCAN (HALT) to exit
the scan mode.
Monitor and Ch-Off:
Used for advanced scan (see
Section 7 of User’s Manual).
Recall – Use to recall stored
scan readings and
statistics.
STORE
OPEN
CLOSE
TRIG
G
EX TRIG
G
To
p
To
p
To
p
Summary of Contents for Integra 27 Series
Page 3: ......
Page 8: ...QuickStartGuide Integra Series...