AR-3000SD (Ver.1.00) Command Reference - 37
PE
Pause and Restart Playback or Recording
Function: Pause and Restart Playback or Recording
Syntax:
stxPE;
(RS-232C, Command format: Type 1)
Syntax:
PE
(Telnet, Command format: Type 1)
Note:
When this command is sent during phrase playback/recording, the AR-3000SD stops
playback/recording and enters the paused state. Sending the PE command again releases
the pause, and playback/recording resumes from where it was paused. When operation is
paused with the PE command, the AR-3000SD outputs the elapsed time from the start of
the phrase to the point where paused. (Refer to 4.4.1 PE command)
Caution:
The command is not compatible with the Dual Mono.
Phrases other than audio phrases cannot be specified.
The AR-3000SD cannot respond to this command during crossfades, repeats or
intervals.
The command is not compatible with audio phrases recorded in Mode 2. (AR-3000SD
will transmit an ER command.)
RM
Recording Standby Mode
Function: Recording Standby Mode
Syntax:
stxRM:a,b,c,d,e,f,g;
(RS-232C, Command format: Type 2)
Syntax:
RM:a,b,c,d,e,f,g
(Telnet, Command format: Type 2)
a: Phrase number
b: RDAC-Grade
3
32
kHz
4
44.1
kHz
5
48
kHz
6
96
kHz
c: RDAC-Mode
5
WAV-16
6
WAV-24
7
MP3-128
8
MP3-192
9
MP3-320
d: Recording type
0
Mono
1
Stereo
e: Trigger recording
0 Off
1 Low
2 Mid
3 High
f: Recording Source
0 LINE - IN
1 MIDI
-
IN
2 LINE + MIC - IN
g: Time base
0 192
1 240
Example)
RM:A1,4,5,1,0,0,0
This sets as follows; phrase “A0001”, “44.1 kHz”, “WAV-16”, “Stereo”, Trigger recording
“OFF”, recording source “LINE-IN”.
Note:
MIDI recording refers to the recording of MIDI messages. If recording source is
“MIDI-IN”, it will enter recording standby mode for a MIDI phrase.
Caution:
It is not possible to specify a phrase number which has already been recorded.
If you wish to re-record a phrase that is already recorded, use the PD command to
delete the phrase, and then transmit the RM command.
The AR-3000SD cannot respond to this command during crossfades, repeats or
intervals.
