OC CONT
Control
Function: CONT
Control
Syntax:
stxOC:a;
(RS-232C, Command format: Type 2)
Syntax:
OC:a
(Telnet, Command format: Type 2)
a: CONT
0
OFF
1
ON
TA Execute
NTP
Function: Execute
NTP
Syntax:
stxTA;
(RS-232C, Command format: Type 1)
Syntax:
TA
(Telnet, Command format: Type 1)
4.2.2 Editing
Commands
DM
Enable Execution of Editing Commands
Function: Enable execution of editing commands
Syntax:
stxDM;
(RS-232C, Command format: Type 1)
Syntax:
DM
(Telnet, Command format: Type 1)
Note:
In order for editing commands to be executed, the DM command must be used to put the
unit into Delete mode. For the communication protocol, refer to 4.1 2) Editing commands.
Caution:
When Delete mode is exited, the AR-3000SD will automatically output a CC command.
The AR-3000SD automatically escapes from the Delete mode two minutes after the DM
command is issued. To run editing commands, send a DM command again to enter the
Delete mode.
Phrase Editing
PD Delete
Phrase
Function: Delete
phrase
Syntax:
stxDM;
stxPD:a;
(RS-232C, Command format: Type 2)
Syntax:
DM
PD:a
(Telnet, Command format: Type 2)
a: Phrase number
PC Copy
Phrase
Function: Copy
phrase
Syntax:
stxDM;
stxPC:a,b;
(RS-232C, Command format: Type 2)
Syntax:
DM
PC:a,b
(Telnet, Command format: Type 2)
a: Phrase number of the copy source
b: Phrase number of the copy destination
Example)
PC:A1,A3
This copies the contents of phrase “A0001” to phrase “A0003”.
AR-3000SD (Ver.1.00) Command Reference - 40
