Scannex ip.buffer User Manual
© UK 2007-2021 Scannex Electronics Ltd. All rights reserved worldwide.
10.7.8. Protocol: iSDX binary
The “iSDX binary” protocol will wait for the initial 0xEE and 0xFF characters of the iSDX
binary format and then collect the rest of the 22-byte frame.
All other data is discarded.
Protocol Parameters
Format
“
Pure Binary
” - Stores the data “as-is”. No time stamping is
performed.
“
ASCII Hex
” – converts the 22-byte binary data into human
readable ASCII hex with a CR/LF at the end. Time
stamping is performed.
[Pure Binary]
10.7.9. Protocol: NEC (STX/ETX) Serial
This protocol is for the serial-connected NEC PBX where each chunk of data is enclosed in
0x02...0x03 binary characters. All other data is discarded
A CR+LF sequence is automatically appended to each frame that is received (because the
NEC does not use CR/LF characters but the ETX character).
Data is tagged as “
cdr nec
”.
Protocol Parameters
Save As
“
Text Lines
” – removes the STX & ETX characters and saves
the CDR records as normal lines of text with a CR/LF.
“
Raw (STX..ETX)
” – keeps the NEC format with STX (0x02) and
ETX (0x03) characters
[Text Lines]
Characters
“
ASCII only
” – strips the high bit from the incoming data and
removes all control characters.
“
ASCII + codes
” – strips the high bit from the incoming data
but keeps control characters.
[ASCII only]
31
The NEC NEAX protocol can also be handled in the “Generic Records” protocol.
32
Be careful if using the Time Stamp feature with the Raw format – your software may not like the
mix of text and NEC records!
Page 80
Scannex ip.buffer User Manual
© UK 2007-2021 Scannex Electronics Ltd. All rights reserved worldwide.
10.7.8. Protocol: iSDX binary
The “iSDX binary” protocol will wait for the initial 0xEE and 0xFF characters of the iSDX
binary format and then collect the rest of the 22-byte frame.
All other data is discarded.
Protocol Parameters
Format
“
Pure Binary
” - Stores the data “as-is”. No time stamping is
performed.
“
ASCII Hex
” – converts the 22-byte binary data into human
readable ASCII hex with a CR/LF at the end. Time
stamping is performed.
[Pure Binary]
10.7.9. Protocol: NEC (STX/ETX) Serial
This protocol is for the serial-connected NEC PBX where each chunk of data is enclosed in
0x02...0x03 binary characters. All other data is discarded
A CR+LF sequence is automatically appended to each frame that is received (because the
NEC does not use CR/LF characters but the ETX character).
Data is tagged as “
cdr nec
”.
Protocol Parameters
Save As
“
Text Lines
” – removes the STX & ETX characters and saves
the CDR records as normal lines of text with a CR/LF.
“
Raw (STX..ETX)
” – keeps the NEC format with STX (0x02) and
ETX (0x03) characters
[Text Lines]
Characters
“
ASCII only
” – strips the high bit from the incoming data and
removes all control characters.
“
ASCII + codes
” – strips the high bit from the incoming data
but keeps control characters.
[ASCII only]
31
The NEC NEAX protocol can also be handled in the “Generic Records” protocol.
32
Be careful if using the Time Stamp feature with the Raw format – your software may not like the
mix of text and NEC records!
Page 80
