4601 I-V Meter Operation Manual
6.6.3 Remote Command List
6-30
Mea-
sure-
ment
Measurement
buffer
memory
RN?
Response:
RNn,adr
n : <d>
adr: <dddd>
SZ?
Reads out the number of stored data.
(0)
*6
Response:
<dddd>
RNM adr
adr:
Specifies the store data number (0 to 4000).
0
*6
When the store data number of the measurement buffer
memory is reached, bit 4 (ASM) of the device event status
register (DSR) is set.
For adr=0, it is set to OFF.
RNM?
Response:
RNMdddd
RDN
adr1,adr2
Specifies the memory range to be read by RDT?.
*9
(0, 0)
*5
adr1:
First recall data number (0 to 3999)
adr2:
Last recall data number (0 to 3999)
RDN?
Response:
RDN adr1,adr2
*9
adr1,adr2: <dddd>
RDT?
Reads out the memory data in the specified range.
*9
(0)
Response:
The comma-separated data in the specified
range is output in the format described in
Section “6.5 Data Output Format.”
• If data does not exist in the specified
number, the output
becomes <EE +8.30>.
• Executing this command releases the
recall execution status.
ZERO
measurement
ZM
Executes ZERO measurement by using the currently set
function, range and integration time.
Temperature
unit
TPU0
Temperature unit
C
TPU1
Temperature unit
F
TPU2
Temperature unit K
TPU?
Response:
TPU0 to TPU2
Resistance bulb
RTD0
Pt100
RTD1
JPt100
RTD?
Response:
RTD0 to RTD1
System
User parameter
STP0
Saves setting parameters to the non-volatile memory, User-0.
STP1
Saves setting parameters to the non-volatile memory, User-1.
STP2
Saves setting parameters to the non-volatile memory, User-2.
STP3
Saves setting parameters to the non-volatile memory, User-3.
SINI
Sets the factory default settings to USER0 through User-3.
RCLP0
Loads data from the non-volatile memory, User-0 as setting
parameters.
RCLP1
Loads data from the non-volatile memory, User-1 as setting
parameters.
RCLP2
Loads data from the non-volatile memory, User-2 as setting
parameters.
RCLP3
Loads data from the non-volatile memory, User-3 as setting
parameters.
RINI
Loads the factory default settings as setting parameters.
Initialization
*RST
Initializes parameters.
(Items except *6 are default values.)
CDV
Device clear (Do not write with other commands in succession
in one line.)
*5:
Not initialized by the RINI command.
*6:
Not initialized by the RINI or *RST command.
*9:
Not specified by USB.
Item
Command
Description
Default
Operation
During
calibration
Power
ON
Factory
shipment
DC
OPR/SUS
Sweep
OPR/SUS
