123
22
ARP
C
OMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
Parameter
create arpentry
<ipaddr> <macaddr>
config arpentry
<ipaddr> <macaddr>
delete arpentry
[<ipaddr> | all]
show arpentry
{ipif system | ipaddress <ipaddr> | static }
config arp_aging time
<value 1-65535 >
clear arptable
Each command is listed in detail, as follows:
create arpentry
Purpose
To insert a static entry into the ARP table.
Syntax
create arpentry <ipaddr> <macaddr>
Description The
create arpentry
command enters an IP address and the
corresponding MAC address into the Switch’s ARP table.
Parameters
<ipaddr>
−
The IP address of the end node or station.
<macaddr>
−
The MAC address corresponding to the IP address
above.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DGS3100# create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DGS3100#
config arpentry
Purpose
To configure a static entry in the ARP table.
Syntax
config arpentry <ipaddr> <macaddr>
Description The
config arpentry
command configures a static entry in the ARP
Table. The user may specify the IP address and the corresponding
MAC address of an entry in the Switch’s ARP table
Summary of Contents for DGS-3100 SERIES
