155
27
LACP
C
OMMANDS
The LACP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
Parameter
config lacp port_priority
<portlist> [priority 1-65535] [timeout <90sec | 3sec>]
show lacp
{<portlist>}
Each command is listed in detail, as follows:
config lacp port_priority
Purpose
To set the priority value of a physical port in an LACP group.
Syntax
config lacp port_priority <portlist> [priority 1-65535] [timeout
<90sec | 3sec>]
Description The
config lacp port_priority
command sets the LACP priority
value and administrative timeout of a physical port or range of ports
in an LACP group.
Parameters
<portlist>
- A port or range of ports to be configured.
<priority 1-65535>
- Specifies the LACP priority value for a port or
range of ports to be configured. The default is 1.
<timeout>
- Specifies the administrative LACP timeout.
•
90sec
– Specifies the LACP timeout to be 90 seconds. This
is the default.
•
3sec
– Specifies the LACP timeout to be 3 seconds.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure the LACP priority of a port:
DGS3100# config lacp port_priority 1 priority 2
Success.
DGS3100#
show lacp
Purpose
To display current LACP port mode settings.
Syntax
show lacp {<portlist>}
Description The
show lacp
command displays the current LACP mode settings.
Parameters
<portlist>
- A port or range of ports whose LACP settings are to be
displayed.
Summary of Contents for DGS-3100 SERIES
