3: Command Line Interface
PremierWave® XC Intelligent Gateway Command Reference
10
To configure the Lantronix locally using a serial port:
1.
Connect a terminal or a PC running a terminal emulation program to one of the 's serial ports.
2.
Configure the terminal to the following settings:
9600 baud
8-bit
No parity
1 stop bit
No flow control.
3.
Power off the device.
4.
Press and hold down the exclamation point (!) key.
5.
Power on the device. After about 1 seconds, the exclamation point will display on the terminal
or PC screen.
6.
Type xyz within 5 seconds to display the CLI prompt.
Navigating the CLI Hierarchy
The CLI is organized into a hierarchy of levels. Each level has a group of commands for a specific
purpose. For example, to configure a setting for the FTP server, one would navigate to the FTP
level, which is under the configuration level.
To move to a different level—Enter the name of the level from within its parent level. For
example, to enter the tunnel level, type
tunnel <number>
at the enable prompt. This
displays:
<enable> tunnel <number>#
.
To exit and return to one level higher—Type
exit
and press the
Enter
key. Typing exit at the
login level or the enable level will close the CLI session. If Line - Command Mode is specified
as Always, a new session starts immediately.
To view the current configuration at any level—Type
show
.
To view the list of commands available at the current level—Type the question mark "
?
". Items
within
< >
(e.g.
<string>
) are required parameters.
To view the available commands and explanations—Type the asterisk (
*
).
To view the list of commands available for a partial command—Type the partial command
followed by the question mark "
?
". For example:
<tunnel-1>#show?
displays a list of all
show commands at the tunnel level.
To view available commands and their explanations for a partial command—Type the partial
command followed by the asterisk (
*
). For example:
<tunnel-1>#show*
displays a list of all
show commands and descriptions at the tunnel level.
To view the last 20 commands entered at the CLI—Type
show history
.
