43
• HELI Defaults:
• PROG.MIX5 aileron-to-elevator for coordinated turns
• PROG.MIX6 aileron-to-elevator for coordinated turns
• Master: The controlling channel can only be a channel. Cannot OFFSET or dial.
• Trim: not available in curve mixes.
• Offset: not available in curve mixes.
Goals
Steps
Inputs
Set up a RUDD-ELEV curve
mix on a model that pitches
down severely at full rudder
and not at all with minimal
rudder input, and pitches
worse on right rudder than
left:
Point 1: 25%
Point 2: 8%
Point 3: 0%
Point 4: 10%
Point 5: 28%
ON when
SWITCHC
is down.
LINK should be ON if model
has twin elevato r servos .
Otherwise, LINK remains
OFF.
(Note that point 3 is 0%.
Otherwise, the elevator would
be retrimmed when the mix is
active and no rudder input is
given.)
Open an unused
programmable mix.(Ex: use
PROG.MIX7 since it is already
set up for FLAP-ELEVATOR)
to BASIC menu,
again to
ADVANCE
to PROG.MIX PUSH
7
，
PUSH
Activate the function
to MIX
，
PUSH
，
to ON, PUSH
Choose master and slave
channels.
Already RUDD. Already ELEV
Set LINK as needed( Ex: off)
Assign SWITCH and position.
(Ex: change from F to C
，
Down)
to SW.PUSH.
to C,PUSH
to POSI, PUSH.
to DOWN
Optional: set switch to
STK-THR to activate mix with
THROTTLE STICK.
to POSI
，
Throttle Stick to desired
point .
Push 1sec.to set.
Optional: set switch position to
NULL. Make mix active at all
time. Not complete with
STK-THR.
to POSI, PUSH,
to NULL
Set desired percent at five
stick points.
to POINT -1
to 25%
，
Repeat for points 2-5.
Close
3.1.2 FLAPERON (ACRO/GLID 1A+1F )
The FLAPERON mixing function uses one servo on each of the two ailerons, and uses them for both aileron
and flap function. For flap effect, the ailerons raise/lower simultaneously. Of course, aileron function (moving
in opposite directions) is also performed.
Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display. (GLID only)
