IPSLA
EtherXtend User’s Guide
133
b
Enter
iplsa modify global state
value
pollseconds
value
to enable
IPSLA and set the pollseconds interval.
zSH>
ipsla modify global state enabled pollseconds 120
c
Verify the IPSLA settings.
zSH>
ipsla show global
state: -------> {enabled}
pollseconds: -> {120}
2
Create a ICMP path between devices. The device on which this command
is entered becomes the initiator device, while the device for which an IP
address is entered becomes the responder device. Typically, one initiator
device can be used to monitor other responder devices in the network over
a maximum of 32 MALC and 4 EtherXtend IPSLA paths per device.
a
Enter the
ipsla add path
command to create the path.
zSH>
ipsla add path ipaddress 172.16.78.11
b
Enter
ipsla show path
command to verify that the IP address was
added.
zSH>
ipsla show path
Path configuration for ipAddress: 172.16.78.11
forwarding: -> {disabled}
state: ------> {enabled}
c
Modify the path using the IPSLA
modify path
command. This
example disables the static path on device 192.168.254.17.
zSH>
ipsla modify path ipaddress 192.168.254.17 state disabled
d
Delete a path using the IPSLA
delete
command.
zSH>
ipsla delete path ipaddress 192.168.254.17
Note:
Disabling or deleting the path or globally disabling the
IPSLA feature will reset historical data.
3
Modify the default CoS actions to specify the response and threshold
behavior for each CoS Action Index (1-8). These CoS actions map
respectively to the CoS queues (0-7) as shown in
CoS actions are defined by default.
Table 23: CoS action index map to CoS queues
Default Name
CoS Action Index
CoS Queue
Default
1
0
AFClass 1
2
1
Summary of Contents for EtherXtend 3300 Series
