STB8827
Series Operation Manual Chapter 7 Command Reference
84
For example: WrtCmd (“CURR 10MA”) Set the measurement current as 10mA.
Query syntax: CURRent?
Return format:<NR3><NL^END>
7.1.5 AMPLitude subsystem commands
The :AMPLitude subsystem commands are mainly used to set the auto level
control (ALC) function as ON or OFF. The :AMPLiture ALC? query returns the
current status of the ALC function.
Command systax:
ON
AMPLitude:ALC OFF
1
0
Where,
Character 1 (49) is equal to ON.
Character 0 (48) is equal to OFF.
For example: WrtCmd (“AMPL:ALC 0”) Set the ALC function as OFF.
Query syntax: AMPLitude:ALC?
Return format: <NR1><NL^END>
7.1.6 Output RESister subsystem commands
The Output RESister subsystem commands are mainly used to set the output
internal resistor mode. The Output RESister? query returns the current output
internal resistance status.
Command syntax:
30
ORESister 50
100
For example: WrtCmd (“ORES 30”); Set the output internal resistance is 30 OHM.
Query syntax: ORESister?
Return format: <NR1><NL^END>
7.1.7 OUTPut subsystem commands
The OUTPut subsystem commands are mainly used to set the DC isolation
function.
