DRAFT
© 2003 - 2005 Sipura Technology, Inc
Proprietary (See Copyright Notice on Page 2)
49
Secure Call Indication
Tone
This tone is played when a call is successfully
switched to secure mode. It should be played
only for a short while (< 30s) and at a reduced
level (< -19 dBm) so that it will not interfere with
the conversation.
ToneScript 397@-19,507@-
19;15(0/2/0,.2/.1/1,.1/
2.1/2)
Notes:
1. Reorder Tone is played automatically when <Dial Tone> or any of its alternatives times out
Distinctive Ring Patterns
8 cadence scripts can be specified to be used as building blocking to construct a ring tone in a RingScript.
Parameter Name
Description
Type
Default
Cadence 1
Cadence 1 script
CadScript
60(2/4)"
Cadence 2
Cadence 2 script
CadScript
60(.3/.2, 1/.2,.3/4)"
Cadence 3
Cadence 3 script
CadScript
60(.8/.4,.8/4)
Cadence 4
Cadence 4 script
CadScript
60(.4/.2,.3/.2,.8/4)
Cadence 5
Cadence 5 script
CadScript
60(.4/.2,.3/.2,.8/4)
Cadence 6
Cadence 6 script
CadScript
60(.4/.2,.3/.2,.8/4)
Cadence 7
Cadence 7 script
CadScript
60(.4/.2,.3/.2,.8/4)
Cadence 8
Cadence 8 script
CadScript
60(.4/.2,.3/.2,.8/4)
Control Timer Values (sec)
Parameter Name
Description
Type
Default
Reorder Delay
Delay after far end hangs up before reorder tone is
played. 0 = plays immediately, inf = never plays.
Range: 0 – 255 sec
Time0 5
Call Back Expires
Expiration time in sec of a call back activation.
Ragne: 0 – 65535 sec
Time0 1800
Call Back Retry Intvl
Call back retry interval in sec. Range: 0 – 255 sec
Time0
30
Call Back Delay
Delay after receiving the first SIP 18x response
before declaring the remote end is ringing. If a busy
response is received during this time, the SPA still
considers the call as failed and keeps on retrying.
Time3 0.5
VMWI Refresh Intvl
Interval between VMWI refresh to the CPE
Time3
0.5
Interdigit Long Timer
2
Long timeout between entering digits when dialing.
Range: 0 – 64 sec
Time0 10
Interdigit Short Timer
2
Short timeout between entering digits when dialing.
Range: 0 – 64 sec
Time0 3
Notes:
1. The interdigit timer values are used as defaults when dialing. The Interdigit_Long_Timer is used after
any one digit, if all valid matching sequences in the dial plan are incomplete as dialed. The
Interdigit_Short_Timer is used after any one digit, if at least one matching sequence is complete as
dialed, but more dialed digits would match other as yet incomplete sequences.