DRAFT
© 2003 - 2005 Sipura Technology, Inc
Proprietary (See Copyright Notice on Page 2)
53
current time to form the local time; otherwise the
offset is added.
Daylight Saving Time Rule
If a rule is specified, the SPA will automatically
adjust for daylight saving time. See “Daylight
Saving Time” Section on syntax of this rule
Daylight Saving
Time Rule
DTMF Playback Level
Local DTMF playback level in dBm (up to 1
decimal place)
PwrLevel -26
DTMF Playback Length
Local DTMF playback duration in seconds (up to 3
decimal places)
Time3 .1
Phone Parameters
General
Parameter Name
Description
Type
Default
Station Name
A name to identify this station (reserved for future use).
Str31
Preferred Audio
Device
Specifies whether to use the headset or the speaker when
pressing a Line key to make a new call or to answer an incoming
call. Choices = {Speaker, Headset}.
Choice
Speaker
Voice Mail Number
A phone number or URL to check voice mail.
Str79
Text Logo
To set the text logo to display when the phone boots up. Default
is (blank) which will show "Sipura Technology". Up to 2 lines of
text can be setup; each line should contain less than 32
characters. A newline character (\n) must be inserted between
the 2 lines and escaped with %0a. For example,
"Super%0aTelecom".
Str32
Line Key n, n = 1–4
Parameters in this section must be appended with [
n
] in the configuration profile
Parameter Name
Description
Type
Default
Extension
Select an extension to be used for this Line key. Choices are
{1,2,3,4} for the 4-Line version and {1,2} for the 2-Line version.
Choice 1
Short Name
A short label to be shown on the LCD display for the Line Key
n
Str15
Share Call
Appearance
Yes indicates Line Key
n
is a shared call appearance. Otherwise
this call appearance is not shared (a.k.a. private)
Bool no
Line Key LED Pattern
Each parameter in this section represents the call appearance state where the specified LED pattern
should apply
Parameter Name
Description
Type
Default
Idle
LED pattern during the Idle state, where the call appearance is
not is in use and is available to make a new call. Leaving this
entry blank indicates the default value of “c=g”
LedScript
Local Seized
LED pattern during the Local Seized state, where this station has
seized the call appearance to prepare for a new outbound call.
Leaving this entry blank indicates the default value of “c=r”
LedScript