Page
42
Basic Programming Commands
Enter Programming:
To begin database programming in LYNX+ from a LCD display phone, press [PRG], [2], Enter Password if
programmed. (New systems will not have a system password). Press [SAVE] key then you will see the
LCD display as follow:
You may now enter the programming Mode (form) you wish to program in the system. When you have
entered the two digit mode, you may need to enter additional digits to access a specific sub-form and Item
Pointer (IP).
Note:
Keys listed between [ ] indicate the default keys shown on a telephone set. Keys listed
between { } indicate the effect they have on programming.
These commands are active while in the system programming mode
[PRG]
{PRG}
:
Moves to the Top Level Programming Mode Display (does not save
information entered into any field unless [SAVE] is pressed first).
[SAVE]
{SAVE}
:
Commits the data that is shown on the LCD display into the system
database.
[DSS 1]
{PREVIOUS}: Moves to the previous section of any multiple part form.
[DSS 2]
{NEXT}: Moves to the next section in any multiple part form.
[DSS 3]
{CURSOR LEFT}: Moves the programming cursor to the left position.
[DSS 4]
{CURSOR RIGHT}: Moves the programming cursor to the right position.
[DND/CN]
{DON’T CARE}: Enters a Wild Card (don't care) into Account Codes or Toll
control entries. LCD will display d (lower case letter "d") to indicate don't care entry.
[HOLD]
{PAUSE}: Inserts a Pause when programming a Speed Dial Entry or for Voice
Mail Programming. LCD will display p (lower case "p") to indicate a Pause entry.
[TRF/FL]
{FLASH}: Enters a FLASH command as part of a Speed Dial Entry. LCD will
display F (upper case "F") to indicate a Flash command. This key also means clears a
digit during other entries (Passwords, etc).
[MSG]
{PULSE > TONE}: Enters a command to convert from pulse dialling to DTMF
dialling into a Speed Dial Entry. LCD will display T (upper case "T") to indicate a tone
conversion command.
[MIC/AT]
{CHANGE}: CHANGE key. Depending on the form, it will toggle through
available Programming parameters.
[TRF/FL]
{CLEAR DIGIT}: Enters a FLASH command as part of a speed dial number.
This key also means clears a digit during other entries (Passwords, etc).
[SPK]
{EXIT}: Exits Programming. Returns telephone to normal idle mode.
PROGRAM MODE: __
(01 – 95)
Summary of Contents for Lynx DK6 Series
