HOST MODE PROGRAMMING
74
A
A SPECIAL
COMMANDS
ID-NET™ SPECIAL COMMANDS
The following special command allows to send strings to a Slave #N through the Master
device in an ID-NET™ reading system layout. In order to send this special command, it is not
necessary to switch the reader into
Host Mode
.
This special command can be used to send
Reading Phase ON
,
Acquisition Trigger
and
Reading Phase OFF
strings (for One Shot and Phase Mode operating modes) to a Slave
device in an ID-NET™ reading system layout.
The Matrix 210™ '
Send String To Slave Device #N
' special command must have the
following format:
<ESC> ( <B0
H
> ADDR STRING ) <ESC>
Where:
ADDR
:
Device Address
STRING
:
String To Send (Length: 1 to 32)
ADDR
is a character indicating address of the device in an ID-NET™ Master/Slave reading
system layout:
ADDR = <30
H
> + <Device Address>
where:
Device Address = 0:
Standalone device or Master ID-NET™ device
Device Address = 1 to 31:
Slave ID-NET™ device
Device Address = 32:
ID-NET™ broadcast address
This means:
ADDR = <30
H
>
:
Standalone device or Master ID-NET™ device
ADDR = <31
H
> to <4F
H
>
:
Slave ID-NET™ device
ADDR = <50
H
>
ID-NET™ broadcast address
Summary of Contents for Matrix 210
Page 1: ...MATRIX 210 Host Mode Programming...
Page 4: ...iv...
Page 80: ...www automation datalogic com...