•
003 Read All Variables:
Returns the input signal in mA, Variable 1 (position) in percent open,
Variable 2 (pressure), Variable 3 (process variable), and Variable 4 (setpoint of process
variable). Process variable and its setpoint are invalid if process controller option is not
enabled.
•
011 Read ID from Tag:
Prompts the user for a tag of device. The tag is sent in a HART
command and if received by a device with a matching tag, the ID of the device is returned.
The format of the ID is the same as command 001 Read Identifier.
•
012 Read Message:
Reads message that was stored in the device when it was configured.
•
013 Read Tag & Descriptor:
Reads tag, descriptor and date that were stored in the device
when it was configured.
•
016 Read Assembly Number:
Reads final assembly number that was stored in the device
when it was configured.
•
017 Write Message:
Selecting this command brings up a dialog, which lets a user enter a
message. This message is written to the SVI.
•
018 Write Tag and Descriptor:
Selecting this command brings up a dialog, which lets a user
enter a tag and descriptor, message, and date. The data is written to SVI.
•
019 Write Final Assembly:
Selecting this command brings up a dialog, which lets a user
enter a final assembly number. This number is written to SVI.
Masoneilan Extended Commands include:
•
210 Read Configuration:
Reads the configuration data from the device and displays it in the
response box. The data include Air-To-Open or Air-To-Close, Single or Double Acting, Fail to
Low or High, Loop (Process) Controller ON or OFF, Characterization, Tight Shutoff, Button
Lock Level, Units and Language.
•
212 Read Error Limits:
Reads and displays the position band and time-outs associated with
position and pressure errors, as well as near closed limit.
•
213 Read Calibration Data:
Reads and displays the input ranges that correspond to the open
and closed positions of the valve, as well as pressure range.
•
216 Read PID:
Reads and displays the positioner tuning parameters include P, I, D, Padj,
beta, Damping, Position Dead Zone, and Position Compensation.
74
