____________________________________________________________________________________
____________________________________________________________________________________
Speeder X1 and X2 Configuration and API Guide
Page 26/36
5.1.2 Trigger count and timing information
The user can get different timing information, such as the trigger event time, time between
trigger events, and trigger occupancy time. The sensor can also be set to count the
triggers.
The trigger event time is the elapsed time from the start of the trigger mode to the trigger
moment. This function is enabled by setting bit 0 of Control Byte 4 (par #50).
Time between trigger events is enabled by setting bit 1 of Control Byte 4 (par #50).
The trigger occupancy time is the time the target is inside the triggering window. It is
enabled by bit 2 of Control Byte 4 (par #50).
Trigger counting can be enabled by bit 4 of Control Byte 4 (par #50).
If all the above-mentioned functions are enabled, the output of the trigger event looks
the following:
Output
Comment
T01234
Target was detected at 12.34 m
ELT: 0:00:09.432
Elapsed time h:mm:ss.sss
INT: 02.321 s
Time from previous trigger in seconds
CNT: 000004
Number of the trigger
OCC: 01017 ms
Time the target was in the triggering window
