IntelliTouch i-Link Protocol Interface Adapter User’s Guide
CMDCHR:
Set/Query Command Character Value
Query:
#CMDCHR ?<cr>
Response:
!00 CMDCHR = x<cr> Where x is the character used to
prefix all Commands. By default this ‘#’
Command:
#CMDCHR = x<cr>
Response:
!00 CMDCHR = x<cr> Where x is the character you wish
to make the
CMDCHR. On Power up or Reset the current value is
displayed.
NRMCHR:
Set/Query Normal Response Character Value
Query:
#NRMCHR ?<cr>
Response:
!00 NRMCHR = x<cr> Where x is the character used to
prefix all Valid (non error) responses from adapter. By
default this ‘!’
Command:
#NRMCHR = x<cr>
Response:
!00 NRMCHR = x<cr> Where x is the character you wish
to make the
NRMCHR. On Power up or Reset the current value is displayed.
ERRCHR:
Set/Query Error Character Value
Query:
#ERRCHR ?<cr>
Response:
!00 ERRCHR = x<cr> Where x is the character used to
prefix all Invalid responses or error messages from
adapter. By default this ‘?’
Command:
#ERRCHR = x<cr>
Response:
!00 ERRCHR = x<cr> Where x is the character you wish
to make the
ERRCHR. On Power up or Reset the current value is displayed.
SETCHR:
Set/Query Set Character Value
Query:
#SETCHR ?<cr>
Response:
!00 SETCHR = x<cr> Where x is the character used as
the operator in all Set commands.
By default this ‘=’
Command:
#SETCHR = x<cr>
Response:
!00 SETCHR = x<cr> Where x is the character you wish
to make the
SETCHR. On Power up or Reset the current value is displayed.
INQCHR:
Set/Query Inquire Character Value
Query:
#INQCHR ?<cr>
Response:
!00 INQCHR = x<cr> Where x is the character used as
the operator in all Query commands. By default this ‘?’
Command:
#INQCHR = x<cr>
Response:
!00 INQCHR = x<cr> Where x is the character you wish
to make the INQCHR. On Power up or Reset the current
value is displayed.
5