DOC06501_Revision
F
ATS-6501 Users Guide
22
ATS-6501>load example
OK
Note:
The system will recognize case sensitive alphanumeric characters, -, ‘ ‘, and _. If any
other characters are used the system will inform the user that the filename is not valid and will not
save the settings.
ATS-6501>save te%^$st
Illegal filename
Users can also remove any configuration files that are no longer needed on the system.
Use the
list
command to bring up a list of the available configuration files and use the
delete
<filename>
command to remove the desired file. Users must provide the filename of the file to
be removed from the system, if not the system will provide an error message reminding the user
to identify the file to be removed.
ATS-6501>delete example
OK
ATS-6501>delete
Error: <filename>
Caution:
Users can delete the
default
file. If this is done and a new user default configuration is
not saved, the system will use the factory defaults when rebooted or power cycled.
2.7.2 FTP and Real-Time (rt) Configuration Files
The ATS-6501 will boot up with the
FACTORY
ftp | rt settings automatically and will
continue to use these settings until any changes to the logging configurations are made
and
saved
as the user default ftp | rt settings (
default
). This will save the updated logging configuration and
the ATS-6501 will use these settings each time the system is rebooted/restarted. To save the
default file simply type
save_logs ftp
or
save_logs rt
. To see if the user settings have been saved
use the
list_logs ftp
or
list_logs rt
command to obtain a list of the possible configuration files. If
there are no user configuration files available the system will report
no files.
ATS-6501>list_logs ftp
ATS-6501>list_logs rt
default
default
or if there are no user files,
ATS-6501>list_logs ftp
no files
Note:
The ftp | rt user
default
files are used at start up if they are available otherwise the system
will use the factory default settings. To modify the ftp or real-time logging behavior, make the
changes needed based on your application and type
save_logs ftp
or
save_logs rt.
Users are
encouraged to set the user default ftp |rt settings based on their application so the system will
properly configure the logging after a reboot or power cycle.
Users can create other logging configuration files. Simply make the desired changes to
the logging configuration, type
save_logs ftp
or
save_logs rt
and a filename to identify the