Programming Manual
–
T3AWG3K-C Series Arbitrary Waveform Generator
True-Arb Operating Mode
31
2.9.7
Clock Group Commands
Use the following commands to set and query the reference and sampling clock parameters
Command
Description
ROSCillator
Sets or returns the reference
clock value in Hz
ROSCillator:SOURce
Sets or returns the reference
clock source to internal or
external
AWGControl:SRATe
This command sets or returns
the sample rate for the clock
Table 20: Clock group commands
2.9.8
IEEE Mandated and Optional Group Command
All AWG IEEE mandated and optional command implementations are based on
the
SCPI
standard
and
the
specifications
for
devices
in
IEEE
488.2.
Command
Description
*CAL?
Runs the self calibration and returns the result. Same as
CALibration[:ALL].
*CLS
Clears all event registers and queues.
*ESE
This command sets or returns the status of Event Status
Enable Register (ESER).
(See Status and events chapter).
*IDN?
This command returns identification information for the
AWG. Refer to Std IEEE 488.2 for additional information.
*OPC
This command causes the AWG to sense the internal flag
referred to as the “No
-Operation-
Pending” flag. The
command sets bit 0 in the Standard Event
Status Register when pending operations are complete.
The query form returns a “1” when the last overlapping
command operation is finished.
*RST
Resets the AWG to its default state.
*SRE
Sets or returns the bits in the Service Request Enable Register
(SRER).
