Vishay Micro-Measurements
System 7000 Programmer’s Reference Manual
Page 61 of 142
6.5 IVMM7000Control Interface Description
6.5.1 Properties
6.5.1.1 IPAddress Property (Read/Write)
Syntax:
Get: HRESULT _stdcall IPAddress(out retval BSTR * Value );
Set: HRESULT _stdcall IPAddress(in BSTR Value );
Description:
Sets or returns the IP Address of the scanner
Notes:
This property must be set before calling the “Open” method. The address is in IPV4 dotted-
decimal notation (e.g. 192.168.0.3).
6.5.1.2 CommandPort Property (Read/Write)
Syntax:
Get: HRESULT _stdcall (out retval long * Value );
Set: HRESULT _stdcall CommandPort(in long Value );
Description:
Sets or returns the command port number for the scanner.
Notes:
This value must be set before calling the “Open” method for the scanner
6.5.1.3 DataPort Property (Read/Write)
Syntax:
Get: HRESULT _stdcall DataPort(out retval long * Value );
Set: HRESULT _stdcall DataPort(in long Value );
Description:
Sets or retrieves the TCP data port to be used when transferring files from the scanner.
Notes:
This value must be set before calling the “Open” method for the scanner