DTMF
Programming
Installation and Programming Manual
3-15
the password, the mailbox owner can retrieve his messages. The duration of remote
notification rings is programmed using code *730.
The VoxBox stops sending Ring notifications after the mailbox owner retrieves all
his new messages or the maximum number of retries has been made (code *750).
The mailbox owner must obtain permission from the System Administrator to
enable remote notification. The System Administrator must use code *710 or *711
to grant permission.
The remote notification activation time can be programmed so the administrator
can decide on the daylights hours for the external notification to be activated. The
time span of this service is programmed using code *490.
When permission has been granted and the mailbox owner enables remote
notification, the VoxBox first dials the external access digit (programmed using
code *340) and then dials the mailbox owner’s remote telephone or pager number.
Note: Make sure that you enter the remote telephone or pager number before
enabling remote notification.
Notification is
always done on the second line
.
3.6.3.1 Setting Notification for Mailboxes
Note: Do not forget to enter programming mode by dialling *900 and the
administrator’s password before using the programming commands.
Note: Virtual mailboxes do not have extensions and may not be configured for
internal notification.
Table 3-6 Commands to Program Notification for Mailboxes
OPERATION
COMMAND
Setting local notification for a range
of mailboxes
*700 + First M Last M X + #
where
X = 0 means notification is disabled
X = 1 means Message Light On 1 is selected
X = 2 means Message Light On 2 is selected
X = 3 means Sign Rings is selected
X = 4 means Rings is selected
Disable local notification for all
mailboxes
*700 + #
