Guppy PRO Technical Manual
V4.1.2
101
Building defect pixel data
The following flow diagram illustrates the defect pixel correction.
Note
While building defect pixel correction data or uploading them
from host, the defect pixel correction data are stored
volatile
in FPGA.
Optionally you can store the data in a
non-volatile
memory
(Set MemSave to 1).
Note
Configuration
To configure this feature in an advanced register, see
.
Note
•
Defect pixel correction is only possible in Mono8 modes
for monochrome models and Raw8 modes for color
models.
•
In all other modes you get an error message in advanced
register 0xF1000298 bit [1] see
•
Using Format_7 Mode_x: Defect pixel correction is done
in
Format_7 Mode_x
.
•
Using a fixed format (Format_0, Format_1 or Format_2):
Defect pixel correction is done in
Format_7 Mode_0
.
•
When using defect pixel correction with
binning
and
sub-
sampling
: first switch to binning/sub-sampling mode and
then apply defect pixel correction.
Figure 41: Defect pixel correction: build and store
Set resolution to format_7 Mode_x with Raw8
or Mono8 color encoding
Or
Set resolution to Format_7 Mode_0 with Raw8
or Mono8 color encoding, when using fixed modes. Set AOI to max.
Set
BuildDPData
to 1
Choose threshold
Set
ON_OFF
to 1
Optional:
Set
MemSave
to 1
Set values for shutter, gain to max.
