6-9
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OL-3418-02 B0
Chapter 6
Configuring Voice over IP
Configuring Basic VoIP
You have many options and great flexibility in configuring dial peers.
Table 6-5
and
Table 6-6
show the
most common configurable options that you can enable in POTS and VoIP dial peers, respectively, from
config or config-dial-peer mode.
Table 6-5
POTS Dial-Peer Configuration Commands
Command
Purpose
answer-address
Sets call-destination number.
application
Sets selected application.
calling-number
Sets calling number (for fgd_eana signaling only).
default
Sets a command to its defaults.
destination-pattern
Sets full E.164 telephone number.
digit-strip
Strips digits from the POTS dialed number.
direct-inward-dial
Sets called number as final call destination.
exit
Exits dial-peer configuration mode.
forward-digits
Configures the destination digits forward of this dial peer.
huntstop
Stops hunting on dial peers.
incoming
Sets incoming called number.
info-digits
Prepends info digits to the calling number.
information-type
Sets information type for dial peer.
max-conn
Sets maximum connections per peer; “no” sets to unlimited.
no
Negates a command or sets its defaults.
numbering-type
Sets calling/called party numbering type.
port
Sets voice port associated with the peer.
preference
Configures preference order of the peer.
prefix
Sets prefix to be dialed before the dialed number.
progress_ind
Indicates call progress.
register
Registers E.164 number of this peer with gatekeeper.
resource
Sets resource allocation policy.
session
Sets session [target | protocol | transport] for this peer.
shutdown
Changes admin state of this peer to down (no->up).
translate-outgoing
Sets translation rule.
