© 2022 HyQuest Solutions
109
Operation
Only sensors that have been selected will be included in this message (see section
for information
one enabling/disabling sensor in the message output). By default, none of the sensors are included so the
message will only contain site name, serial number and date/time.
The limit of the size of message that can be set is 160 characters. This means that it is important to consider
which sensors are included in the message.
INT – change call-in schedule on INTerval
This command changes the call-in schedule On Interval setting (see section
from
information on configuring this setting via iLink), allowing the user to increase or decrease the update rate of data sent
out via the cellular telemetry module.
The message is in the format:
INT=t
Where
t
is the interval in units of minutes.
Example:
Will change the schedule interval to 60 minutes
The iRIS will respond to this command with an SMS message with contents in the format:
<SiteName> (<SerialNumber>)<DateTime>: On Interval for module <n> now <t> mins.
Where elements are as follows:
Element
Description
<SiteName>
Site name of the iRIS.
<SerialNumber>
Serial number of the iRIS.
<DateTime>
Time of the message as it is sent using the iRIS local settings.
<n>
Module number (either 1 or 2).
<t>
Interval time (minutes) that has been change to.
For example:
56
43
