-18-
● ID Filter
Select the ID filter from “OFF”(invalid), “Acceptance”, “Pass”, “Cut”, “Pass & Cut”, or “Acceptance &
Pass & Cut”.
・
Acceptance
Captures the frames which have corresponding ID by a hardware filter.
You can set bit-by-bit (“0”, “1”, “*”, (Don’t care)) from high-order bit by acceptance
configuration tab. Configure values for ID28 - ID18 (values for ID17 - ID0 should be “Don’t care”)
when it is standard format, and configure values for ID28 – ID0 when it is extended format.
(Example) When it is standard format and captures the frames with ID “010h”(HEX).
Note: When extended format are mixed with standard format, 00400000h - 0043FFFFh
also will be captured.
・
PASS
Captures the frames which have corresponding ID by a software filter.
Select standard format of extended format at the pass configuration tab and set the ID by HEX
(“0” - “F”, “*”, (Don’t care)). (You can set up to 8 items)
Configure values within the scope of ID:0 – 7FFh when it is standard format,
and configure values within the scope of ID:0 – 1FFFFFFFh when it is extended format.
Note: If there is no entry for the blanks when the pass filter is valid, no ID frame will be captured.
(Example) Monitoring of the IDs of 010h – 01Fh when it is standard format and the ID is configured
for 01*h (HEX).
