MeshLinx MWI-5000 User Guide
MESHLINX CONFIDENTIAL
2
start
autoconfig
To stop and disable
Autoconfig
/
LnL
when
Autoconfig
/
LnL
is running
stop
autoconfig
set
autoconfig
disable
4.2.3.17
HTTP Server
get http
– get all HTTP parameters
get http wlanaccess
– display Ethernet access
get http ethaccess
– display Ethernet access
get http port
– display port number
set http [enable | disable]
– set HTTP state
set http port <int>
- set port number
Note:
WEP is enabled when either
open enencryp
or
share enencryp
is set;
disabled when both
open disencryp
and
share disencryp
are set.
4.2.3.18
Security
This section lists CLI commands used to display and configure the
MWI-5000 security features.
The following commands display and modify the global security
settings for the AP.
set ap security [legacy-clear|legacy-encrypt|wpa|wpa2|wpa+wpa2|tsn]
Sets the global security mode for the AP. The following table
shows the type of wireless stations allowed to associate for
each security mode.
get ap security -
Displays the selected security mode.
The following commands are used to display and modify security
settings when the MWI-1500 System is configured for legacy-encrypt
mode.
set ap keylength [64|128]
– Sets static WEP key length (64-bit or
128-bit).
get ap keylength
- Displays the static WEP key length.
get ap keyselect
- Displays the static WEP key index used for
encrypting packets prior to transmission.
The following commands are used to display and modify security
settings when the MWI-1500 System is configured for the wpa, wpa2,
wpa+wpa2, or tsn security modes.
get ap wpa
-
display the WPA security configuration.
