LambdaDriver 400 & 800
ML46430, Rev. 07
October 2004
Command
set-trans-primary-state
Description Activate primary or secondary transponder. (The other transponder of the pair
goes into standby.)
Syntax
set-trans-primary-state [arg #0] opt.[arg #1]
where,
[arg #0] = <slot number>.
opt.[arg #1] = <p|s>
p
= primary mode
s
= secondary mode
Default
Example
SYS_console>set-trans-primary-state 2 p
set-trans-primary-state:
Transponder card in slot 2 primary/secondary state is Primary .
SLT CARD_TYPE Redundant Primary/Secondary
========================================
1 TM-SFP-C Redundant Secondary
2 TM-SFP-C Redundant Primary
----------------------------------------
Notes
–
opt.[arg #1] = primary
Command
get-adc-lambda-info
Description Show information (e.g., operating wavelength, etc.) on OADM modules (ADC =
Single-interface, ADCD = Dual-interface).
Syntax
get-adc-lambda-info opt.[arg #0]
opt.[arg #0] = <slot>-<slot>-<slot>
and/or
<slot>..<slot>
i.e., individual slot numbers separated by
hyphens, or range of slot numbers.
opt.[arg #0] =
all slots
SYS_console>get-adc-lambda-info
SLT CARD_TYPE WDM #Ports #L1 #L2 #L3 #L4 #L5 #L6 #L7 #L8
========================================
2 ADCD CWDM 4 1470 1490 1510 1530
3 ADCD CWDM 4 1550 1570 1590 1610
Notes
–
Default
Example
Command
get-sfp-spec-info
Description
Syntax
[arg #0] = <slot>-<slot>-<slot>
and/or
<slot>..<slot>
i.e., individual slot numbers separated by
hyphens, or range of slot numbers.
[arg #1] = <port>-<port>-<port>
and/or
<port>..<port>
i.e., individual port numbers separated by
hyphens, or range of port numbers.
Default
–
Example
SYS_console>get-sfp-spec-info 8 0
Identifier : SFP
Connector : LC
Show SFP vendor data.
get-sfp-spec-info [arg #0] [arg #1]
160
