6 Command Line Interface
D-Link Web Smart Switch User Manual
96
show ipif [<ipif_name>]
Displays the current IPv4 and IPv6 address of the interface.
show switch
Show system information.
config account admin password
<passwd>
Configure password.
save
Save configuration.
debug info
Displays Debug Table.
Each command is listed in detail, as follows:
?
Purpose
To display a list of commands.
Syntax
?
Description
The
?
command displays a list of commands of the switch.
Parameters
None.
Restrictions
None.
Example usage:
To display a list of commands of the switch:
DGS-1500-28> ?
USEREXEC commands :
config account admin password <passwd>
config ipif <ipif_name> { ipaddress <ip-address> <subnet-mask> gateway <gw-
address> | dhcp | bootp }
config ipif <ipif_name> { ipv6 ipv6address <ipv6networkaddr> | dhcpv6_client {
enable | disable}}
debug info
download { firmware_fromTFTP | cfg_fromTFTP} {<ipaddr>|<ipv6addr>}
<path_filename>
logout
ping <ip_addr>
ping6 <ipv6addr>
reboot
reset config
save
show ipif [<ipif_name>]
show switch
upload { firmware_toTFTP | cfg_toTFTP} {<ipaddr>|<ipv6addr>} <path_filename>
DGS-1500-28>
download
Purpose
To download and install a firmware, boot, or switch configuration
file from a TFTP server.
Syntax
download { firmware_fromTFTP | cfg_fromTFTP} {<ipaddr> |
