Isolated application execution with Docker
223/263
Ê
The fields
host
and
container
are shown on the page "Container list".
Ø
Field
host
: Enter the port, e.g.
8080
, where the NGINX can be
accessed via the web browser.
Ø
Field
container
: Enter the port, e.g.
80
, that NGINX uses within the
container.
Figure 144: NGINX example - screen page "Create container"
Ø
If required, set the
Advanced options
according to the documentation
of the container to be started (in this case: NGINX documentation,
https://hub.docker.com/r/_/nginx/
). This example does not require any
further settings.
Ø
Click
.
ð
The configuration of the container is thus ready for the execution of
NGINX. Docker will first load the image from the registry (duration 2-3
minutes), deposit it in the Edge Gateway, and transform it into a
container thereafter. This container will then appear in the container list
and its status changes to
running
.
To check the correct installation of NGINX, proceed as follows:
Ø
Enter the following address in the adress line of your web browser:
http://<IP-address of your device>:8080
ð
The NGINX-start screen will be displayed.
Edge Gateway | NIOT-E-TIB100-GB-RE (Remote)
DOC170501UM04EN | Revision 4 | English | 2018-08 | Released | Public
© Hilscher 2017 – 2018
